94-99 Dodge Ram 5 lug 9.25 rear with 3.55 gear. This axle was in good working condition and only 130k. Sold complete drum to drum with the speed sensor and brake soft line uncut. Heavy rust especially on backing plates, throw a spring kit on the brakes and you can run it no problem. Only asking $250 because of the rust. LOCATED IN WALLINGFORD CT
Lincoln Versaille Rear End Assy- Dont know exact year - 3.25 ratio- non-posi- 9 inch disc brake-have caliper cores but includes new rotors and e-brake cables-$400 or b.o.-Call
Returns Accepted: Returns Accepted Item must be returned within: 14 Days Refund will be given as: Money Back Return policy details: 20% Restocking fee on all unwanted, unused returns in orginal packaging or tags. Return shipping will be paid by: Buyer Restocking Fee: No Part Brand: PIVOT WORKS Manufacturer Part Number: PU0215-0182/WE52-0573 Placement on Vehicle: Rear Warranty: No Fits: ATV YOU ...
Returns Accepted: Returns Accepted Item must be returned within: 14 Days Refund will be given as: Money Back Return policy details: THERE IS A 20% RESTOCKING FEE ON ALL RETURNS OR EXCHANGES. PLEASE MAKE SURE YOU ARE PURCHASING THE CORRECT PART THAT YOU NEED. Return shipping will be paid by: Buyer Restocking Fee: No THIS AUCTION IS FOR A NEW REAR AXLE LOCKNUT AND WASHER FOR THE FOLLOWING MODELS ...
Returns Accepted: Returns Accepted Refund will be given as: Money back or exchange (buyer's choice) Item must be returned within: 60 Days Return policy details: If for any reason your are not satisfied with your purchase, eEuroparts.com will accept the return of the product(s) only if in the original saleable condition within 60 days of purchase with 15% restocking fee. No returns after 60 days...
Condition: New Placement on Vehicle: Rear Fits: ATV Warranty: No Brand: Moose Racing/All Balls Part Brand: ALL BALLS Manufacturer Part Number: A25-1122 UPC: Does not apply THIS LISTING IS FOR A NEW SET OF REAR AXLE BEARINGS FOR THE FOLLOWING MODELS LISTED BELOW . THIS IS A COMPLETE KIT WITH 2 SEALS AND 2 SEALED AXLE BEARINGS.THESE ARE BETTER THAN OEM BEARINGS AND LAST MUCH LONGER. HONDA: 1983-1...
Returns Accepted: Returns Accepted Refund will be given as: Money back or exchange (buyer's choice) Item must be returned within: 60 Days Return policy details: If for any reason your are not satisfied with your purchase, eEuroparts.com will accept the return of the product(s) only if in the original saleable condition within 60 days of purchase with 15% restocking fee. No returns after 60 days...
Returns Accepted: Returns Accepted Refund will be given as: Money back or exchange (buyer's choice) Item must be returned within: 60 Days Return policy details: If for any reason your are not satisfied with your purchase, eEuroparts.com will accept the return of the product(s) only if in the original saleable condition within 60 days of purchase with 15% restocking fee. No returns after 60 days...
Similar
Parting 96 GT. Lots good stuff. Call for parts and prices. Lots of good parts, trunk lid 50, interior, airbags-300 for set, dash cluster 125, lowering springs 150, RT fender 75, brakes 150 for all, rear axle 3.73 posi 250, sun roof 75, windshield 75 u-pull it. Rear glass 75 u-pull it. Cowl filler 50, lots of small items also, full part out . Spoiler and hood have been sold.
99-03 Lexus Rx300 PartsHave a lot of OEM Parts available Left front doorPassenger rear door assembly Front fenders Awd axles Ac compressor Ac lines Ac condenserAlternatorStarter Passenger seat All heads rests Steering wheel Airbags Passenger side tail light Glove box Trim Full sunroof assembly Steering rack Brake master cylinder Antenna motor only Radiator FANS Shroud Wiper linkage Front and re...
narrowed ford 9 inch rear for drag racing The rear has aftermarket 31 spline Sumner brothers axles with extended wheel studs, spool, drum brakes with new hardware, and is setup for four link suspension. Comes with a center section with gears high 2s low 3s, I dont remember exactly as well. $1000 Firm.
Clean take out spider gears out of a 35 spline Dana 60 rear axle. Only removed to install a locker, should work on Ford, Chevy or Dodge D60s but should verify fitment prior to installationpurchase. Asking $40 OBO for the setup, if interested call or text .
Mercedes 190e 16v Cosworth PARTS ONLY -Passenger fender -Trunk with spoiler complete $480-Wood shifter trim $180 -Center console $150-All interior carpets -All doors-Heater box -Sunroof assembly -All of the ECU Relays -Rear subframe assembly -Rear axles hubs And a lot of misc parts Parts that are NOT available Engine, transmissionswap, hood, driver side fender, bumpers, lip kit. W201 190e Cossi...
87 Monte Carlo Dragcar roller. All steelglass car,solid clean car. Stock suspension trick springs drag shocks, air bags and rear swaybar Grand national rear 430 spool Moser axles stud girdle Weld draglines 6 point bar. Weighs just under 3k with small block power glide setup
IF A PART IS LISTED BELOW WITH A PRICE THEN IT IS AVAILABLE. YOU WILL SEE A LIST OF NOT AVAILABLE PARTS, THEY ARE NOT AVAILABLE.IF YOU DO NOT SEE A PART LISTED, THEN ASK AND I WILL GIVE YOU A PRICE.THE TRUCK IS LOCATED IN CANTON, CTNOT AVAILABLE automatic transmission and related accessories, transfer case, front differential, gas tank until motor is sold, and rimstires.SOLD PARTS BOTH BUMPERS,...
Parting out. List of parts sold are at the end of the post. Front axle 3.55 gears $50. Both rear doors complete $25 each. Passenger side glass with window motor and regulator $10. for all. Rim and tires only have two $25 each. Rear hatch glass $10. Passenger front seat $25. Driver front seat a little worn $10. Rear driver side taillight $25. Alternator $25. Starter $25. Door panels $10 each. Fr...
1955-64 Chevrolet Carrier for an 8.2 rear axle. In very good condition out of my 1957 Chevrolet that I decided, probably stupidly, to put an Eaton Posi in. 1957, 1956, 1955, 1958, 1959, 1960, 1961, 1962, 1963, 1964, 55, 56, 57, 58, 59, 60, 61, 62, 63, 64 Chevrolet, Nomad, Townsman, BelAir, Bel Air Del Ray, DelRay, Handyman, Handy Man, Sedan Delivery, 150, 210, Impala, Biscayne,
I acquired a 1930 Model A Pick-Up Truck from the estate of a local gentleman that restored them. The purchase included an inventory of a variety of used parts, for which I really have no use for. It appears the parts are from model years 1928-1930. The gentleman restored Model A roadsters, sedans and pick-ups. I have front rear fenders, pans, drums, steering columns, axles, taillights, bell hou...
1 + ... Next >